Route Show; Session; Session Timeout Close - Zte ZXR10 8900 Series Command Manual

ZXR10 8900 Series Command Manual (FW Volume)
Command
Function
Command Format
Parameter
Description
Example
Command
Function
Command Format
Parameter
Description
Example
108 Confidential and Proprietary Information of ZTE CORPORATION

route show

This command is used to show route configuration.
route show [total | dynamic num <number1> page <number
2>]
Parameter
total
dynamic num
<number1>
<number2>
To show route configuration information on page1 in mode of dis-
playing 10 pieces per page, execute the following command:
# route show dynamic num 10 page 1

session

This is about settings of session.

session timeout close

This command is used to set session timeout close.
session timeout close <number|default>
Parameter
number
default
To set the default session timeout to 600 seconds for closing, ex-
ecute the following command:
# session timeout close default
To set the session timeout to 200 seconds for closing, execute the
following command:
# session timeout close 200
Description
This shows the total number of entries in
routing table.
This shows routing table according to specific
setting.
This is one number, showing the number of
ARP entries displayed on each page, in range
of 1-100.
This is one number, which is the start page
number of routing table, in range of 1-65535.
Description
This is one number, ranging from 3 to 800.
This sets default timeout.