Alarmnotice Modify Mail - Zte ZXR10 8900 Series Command Manual

ZXR10 8900 Series Command Manual (FW Volume)
Parameter
Description
Command
Illustration
Example
Command
Function
Command Format
86 Confidential and Proprietary Information of ZTE CORPORATION
Parameter
modify
<beep>
name
<string>
<default>
freq
<number1>
length
<number2>
reps
<number3>
delay
<number4>
When the attribute of beep alarm is set to default, the default
values of parameters are as follows:
frep
length
reps
delay
To use specific values for parameters of beep1 alarm rather than
use default values, execute the following command:
# alarmnotice modify beep name beep1 freq 10 length
100 reps 5 delay 80

alarmnotice modify mail

This command is used to modify one mail alarm-related parameter.
alarmnotice modify <mail> name <string1> srvaddr <ipaddre
ss> srvport <number> mailaddr <string2>[subject <string3>]
Description
This command is used to modify one beep
alarm.
This indicates the alarming mode is beep
alarm.
This specifies the name of alarm to be
modified.
This is a string, indicating the name of alarm.
This uses the default value of beep alarm.
With this option, it doesn't need to modify the
following parameters.
This sets beep output frequency.
This is one number, indicating beep output
frequency, in HZ, in range of 1-1000HZ.
This sets beep length.
This is one number, indicating beep length,
in micro-seconds, in range of 1-1000
micro-seconds.
This sets repeat times of beep.
This is one number, indicating beep repeat
times, in times, in range of 1-1000 times.
This sets the interval of two beeps.
This is one number, indicating beep interval,
in micro-seconds, in range of 1-1000
micro-seconds.
440HZ
200 micro-seconds
5 times
100 micro-seconds