Operation Mode At Power On (Pr. 79, Pr. 340) - Mitsubishi Electric FR-E700 Instruction Manual

Selection of operation mode and operation location
6.18.2

Operation mode at power on (Pr. 79, Pr. 340)

When power is switched on or when power comes back on after instantaneous power failure, the
inverter can be started up in network operation mode.
After the inverter has started up in the network operation mode, parameter write and operation
can be performed from a program.
Set this mode for communication operation using the inverter RS-485 terminals or communi-
cation option.
Pr.
Name
No.
Operation mode
79
selection
Communication
340
start-up mode
selection
The above parameters can be changed during a stop in any operation mode.
The above parameter can be set when Pr. 160 "User group read selection" = 0. However,
the parameters can be set whenever the communication option is connected. (Refer to
section 6.17.4.)
6 - 210
Initial Setting
Description
Value Range
Select the operation mode.
0 0–4/6/7
(Refer to page 6-201)
0 As set in Pr. 79.
1 Started in network operation mode.
Started in network operation mode.
0
Operation mode can be changed between
10 the PU operation mode and network
operation mode from the operation
panel.
Parameter
Parameters referred to
79 Operation mode
selection
Refer to
Section
6.18.1