Easy Operation Mode Setting (Easy Setting Mode) - Mitsubishi Electric FR-E700 Instruction Manual

Operation panel
4.3.3

Easy operation mode setting (easy setting mode)

A frequency inverter can be controlled alone via the control unit, through external signals
(switch, SPC outputs, external setpoint sources, etc.) or through a combination of external sig-
nals and inputs to the control unit. The choice of operation mode is done by setting parameter
79. (Refer to section 5.1.6.)
Setting of Pr. 79 "Operation mode selection" according to combination of the start command and
speed command can be easily made.
In the following example the parameter is set to the value "3" so that the motor is started by sig-
nals to the STF and STR terminals and the speed can be adjusted using the digital dial on the
operator device.
Screen at powering on The monitor display
appears.
Press PU/EXT und MODE for 0.5s.
Turn the digital dial, until "3"
apears. (Refer to the table on the next page for
other settings.)
Press SET to set.
Fig. 4-8: One can immediately change parameter 79 by simultaneously pressing the PU/EXT
NOTES Press MODE before pressing SET to return to the monitor display without setting. In this
case, the mode changes to external operation mode when performed in the PU operation
mode (PU JOG operation mode) and PU operation mode when performed in the external
operation mode.
Reset can be made with STOP/RESET.
4 - 10
Operation
and MODE buttons.
Operation
Display
Flickering
Flickering
Flickering
Flicker ... Parameter setting complete!
The monitor display appears after 3 s.
I001737E, I001738E