When Pr. 495 = 0 or 10, performing a power supply reset (including a power failure) clears the
REM signal output. (The ON/OFF states of the terminals are as set in Pr. 190 to Pr. 192.) The
Pr. 496 and Pr. 497 settings are also "0".
When Pr. 495 = 1 or 11, the remote output data before power supply-off is stored into the
E²PROM, so the signal output at power recovery is the same as before power supply-off. How-
ever, it is not stored when the inverter is reset (terminal reset, reset request through commu-
nication). (See the chart below).
When Pr. 495 = 10 or 11, signal before rest is saved even at inverter reset.
Fig. 6-66: ON/OFF example for source logic
The output terminal where the REM signal is not assigned using any of Pr. 190 to Pr. 192
does not turn on/off if 0/1 is set to the terminal bit of Pr. 496 or Pr. 497. (It turns on/off with
the assigned function.)
When the inverter is reset (terminal reset, reset request through communication), Pr. 496
and Pr. 497 values turn to "0". When Pr.495 = 1 or 11, however, they are the settings at
power off. (The settings are stored at power off.) When Pr. 495 = 10 or 11, they are the
same as before an inverter reset is made.
Pr. 495 = 0, 10
REM signal clear
Function assignment of external terminals
Pr. 495 = 1, 11
REM signal held
Inverter reset time
6 - 135