Parameter
The following diagrams show how the jump point is selected. The diagram on the left shows a
sequence in which the jump takes place at the end of the area to be jumped, for which the lower
frequency must be entered first. In the diagram on the right the jump takes place at the beginning
of the frequency area to be jumped, for which the higher frequency must be entered first.
Fig. 6-12: Selection of the jump point
NOTE
During acceleration/deceleration, the running frequency within the set area is valid.
FR-E700 EC
Hz
38
32
Set frequency
Hz
38
Pr.32 (1B)
32
Pr.31 (1A)
Limit the output frequency
Pr.31 (1A)
Pr.32 (1B)
Set frequency
I00019aC
6 - 53