Mitsubishi Electric FR-E700 Instruction Manual page 389

Parameter
● Run command
Item
Run
command
Run
command
(extended)
Tab. 6-78: Run commands
The signal within parentheses is the initial setting. The description changes depending on
the setting of Pr. 180 to Pr. 184 "Input terminal function selection". (Refer to section 6.10.1.)
The signal within parentheses is the default setting. Reset cannot be controlled by the
network, bit 11 is invalid in the initial status. When using bit 11, change the signal with Pr. 184
"RES terminal function selection" (section 6.10.1) (Reset can be executed with the instruc-
tion code HFD.)
When Pr. 551 = 2 (PU Mode control source is PU connector), only forward rotation and
reverse rotation can be used.
FR-E700 EC
Instruction
Bits Description
Code
b0: AU (current input
selection)
b1: Forward rotation start
b2: Reverse rotation start
b3: RL (low speed)
HFA 8
b4: RM (middle speed)
b5: RH (high speed)
b6: RT (second function
selection)
b7: MRS (output stop)
b0: AU (current input
selection)
b1: Forward rotation start
b2: Reverse rotation start
b3: RL (low speed)
b4: RM (middle speed)
b5: RH (high speed)
b6: RT (second function
selection)
b7: MRS (output stop)
HF9 16
b8: —
b9: —
b10: —
b11: RES (reset)
b12: —
b13: —
b14: —
b15: —
Communication operation and setting
Example
Example 1: H02 (Forward rotation)
Example 2: H00 (Stop)
Example 1: H0002 (Forward rotation)
Example 2: H0800 low speed operation
(When Pr. 184 "RES terminal function selection" is set
to "0")
6 - 249