Mitsubishi Electric FR-E700 Instruction Manual page 359

Parameter
Communication operation com-
mand source (Pr. 338)
Operation
Location
Communication speed command
Selection
source (Pr.339)
Output stop
PU operation interlock
24 MRS
25 STOP Start self-holding selection
60 STF Forward rotation command
61 STR Reverse rotation command
62 RES Reset
65 X65 PU-NET operation switchover
External-NET operation
66 X66
switchover
67 X67 Command source switchover
Tab. 6-62: Writing operation and speed commands (2)
Explanation of table:
External:
NET:
Combined:
—:
NOTES The control source of communication is as set in Pr. 550 and Pr. 551.
The Pr. 338 and Pr. 339 settings can be changed while the inverter is running when Pr. 77 =
2. Note that the setting change is reflected after the inverter has stopped. Until the inverter
has stopped, communication operation command source and communication speed com-
mand source before the setting change are valid.
FR-E700 EC
0: NET
1:
0: NET Exter-
nal
Combined
—
NET
NET
Operation is valid only from external terminal signal.
Control only from communication is valid.
Operation is valid from either of external terminal and communication.
Operation is invalid from either of external terminal and communication.
Selection of operation mode and operation location
1: External
2: 1:
Exter- 0: NET Exter-
nal nal
External
External
External
External
External
External
External
External
External
Remarks
2:
Exter-
nal
Pr. 79 ≠ 7
Pr. 79 = 7
(When X12 signal
is not assigned)
6 - 219