Rear Sensor Position - Epson Stylus Pro 10000 Service Manual

EPSON Stylus Pro 10000/10000CF/10600

5.4.4.14 Rear sensor position

This adjustment to detect the form length of cut paper precisely. The position of rear
sensor inside firmware is adjusted on the basis of the nozzle to secure the maximum
Pause range from the paper edge. Set the A3 cut sheet paper in direction of side put and
cause a horizontal line (1 of dot line of black) printing in the place of 14 mm from the
paper edge and measure the length of it from edge then input the value revision. This
adjustment is not necessary at the field even if band correction is performed, although
this item is necessary in a production process. Cut sheet is required without the
condition of cut sheet placement when this item is selected. Figure 5-69 showing menu
sequence and Figure 5-70 showing print pattern.
Please Set Cut Sheet
Enter
Printing Pattern
Print END
Paper Width xxx.xmm
Enter
Rear Sen. Pos. : xx.xmm
Figure 5-69.
Measure the length between the paper edge to printed line and input the rear sensor
position.
Adjustment
Thank You For Using TheServiceManualShop.com
Eject the sheet after the
printing.
Shift to the "RearSen.Pos.:xxmm"
with "Pause" key.
Adjust the position with unit
0.1mm by "Paper feed+/-" key.
Thank You For Using TheServiceManualShop.com
Shift to the "Test print" by pressing "Enter" key during the "Rear sensor" display.
Self-Diagnostics
Rear sensor position
correction
Paper Feed
Figure 5-70.
Revision D
241