Rear Sensor Position Adjustment - Epson Stylus Pro 9000 - Print Engine Service Manual

EPSON Stylus Pro 9000

REAR SENSOR POSITION ADJUSTMENT

This function makes sure the Rear Paper Sensor correctly detects the rear
edge of cut-sheet paper. After the printer makes a line near the rear edge of
the paper, measure the distance from the line to the paper's edge, and then
enter this measurement when prompted.
1. Make sure "Adj Rear Sensor Pos." appears, and press the Enter button.
2. When you see the "Please Set Cut Sheet" message, load a sheet of cut-
sheet paper, short edge first. After the paper is set, press the Enter button
to print the check pattern.
3. After printing is finished, measure the distance from the rear edge of the
printed pattern to the rear edge of the paper. Press the SelecType or Item
button until you see "RearSen. Pos. xx.xmm", and then enter the
measurement in increments of 0.1 mm using the Paper Feed +/- buttons.
4. After entering the measurement, press Enter.
Please Set Cut Sheet
Load cut-sheet paper short edge first.
[Enter]
Printing Pattern
Paper Width 627mm
[Enter]
RearSen. Pos.
Adjustments
Enter the value
with the Paper
Feed [+] or [-]
+3mm
button.
End
[Enter]
adjustment/
next menu
Measure this value
and enter it.
direction
Figure 5-13. Rear Sensor Position Measurement
Feed
126