Paddle Section - Konica Minolta Bizhub C350 Service Manual

Other
[12]
[13]
[11]
[6]
[10]
[18]
[17]
1.3.14

Paddle Section

[2]
[2]
[4]
[5]
bizhub C350 Field Service Ver.1.0 Mar. 2004
[14]
[16]
[15]
4583fs2547c0
4583fs2525c0
[1]
4583fs2548c0
[3]
[4]
4583fs2549c0
[6]
4583fs2550c0
2-12
7. Remove the C-clip [10], and remove
the spacer [11], and remove the Tim-
ing Belt [13] from the Gear [12].
8. Unplug the connector [14], and
remove the Harness [16] from the
Wire Saddle [15].
9. Remove two screws [17], and
remove the Finisher Tray [18] by slid-
ing it to the far side and lifting it.
1. Remove the Finisher Tray.
☞ 2-11
2. Place the Finisher Tray [1] as shown
in the figure.
NOTE
• Be careful not to damage the Align-
ing Plate [2].
3. Remove the Timing Belt [3], and
remove two screws [4].
4. Separate the section into the Tray
Section[5] and the Paddle Section
[6].