Center Binding Position (Fs-501 Only) - Konica Minolta Bizhub C350 Service Manual

bizhub C350 Field Service Ver. 2.0 April 2004
4.4.11

Center Binding Position (FS-501 only)

Functions • To adjust the positions of center staple and folding for the Finisher.
Use • Use when the center staple and folding positions deviate from the correct ones in the
copies made using the Booklet function.
Adjustment • Center staple position:
Specification The adjustment range is -7.0 mm to +7.0 mm (in 1-mm increments).
• Fold position:
The adjustment range is -7.0 mm to +7.0 mm (in 1-mm increments).
Adjustment If deviated to the left, increase the setting value.
Instructions If deviated to the right, decrease the setting value.
Adjustment 1. Use the Booklet function to make one sample booklet.
Procedure 2. Call the Tech. Rep. Mode to the screen.
3. Machine Adjust → Center Binding Position.
4. Check the sample copy and make the necessary adjustment as detailed in the fol-
lowing.
Adjusting the center staple position:
5. If the staple positions deviate, use these steps to make the adjustment.
If the staple positions deviate to the left side, increase the setting value.
If the staple positions deviate to the right side, decrease the setting value.
Adjusting the folding position:
6. If the folding position deviates, use these steps to make the adjustment.
If the folding position deviates to the left side, increase the setting value.
If the folding position deviates to the right side, decrease the setting value.
7. Quit the Tech. Rep. Mode.
8. Using the Booklet function, make another sample booklet for confirmation.
9. Check the sample copy and repeat the adjustment procedures until there are no
deviations in the staple or folding position.
Deviated to left
4036fs3011c0
Deviated to left
4036fs3013c0
3-57
TECH. REP. MODE
Deviated to right
4036fs3012c0
Deviated to right
4036fs3014c0