Paddle Section - Konica Minolta bizhub C450 Service Manual

2. Other
[6]
[4]
[8]
[7]
[12]
[13]
[11]
[6]
[10]
[18]
[17]
2.3.12

Paddle Section

[2]
[2]
12
[5]
[4]
[3]
4583fs2522c0
[9]
4583fs2523c0
[14]
[16]
[15]
4583fs2547c0
4583fs2525c0
[1]
4583fs2548c0
Field Service Ver. 1.0 Mar. 2005
4. Pull out the Finisher Stopper Base
[3], and disengage the front claw [5]
and the rear claw [6] of the Finisher
Stopper [4].
5. Remove the Motor Harness [8] from
two Harness Saddles [7].
6. Unplug three connectors [9].
7. Remove the C-clip [10], and remove
the spacer [11], and remove the Belt
[13] from the Gear [12].
8. Unplug the connector [14], and
remove the Harness [16] from the
Wire Saddle [15].
9. Remove two screws [17], and
remove the Finisher Tray [18] by slid-
ing it to the far side and lifting it.
1. Remove the Finisher Tray.
☞ 11
2. Place the Finisher Tray [1] as shown
in the figure.
NOTE
• Be careful not to damage the Align-
ing Plate [2].