Konica Minolta Bizhub C350 Service Manual page 386

Firmware rewriting
6. Specify the Drive of Compact flash, which was recognized through the procedure 3,
and execute the "mkcf.bat".
(Input the C:\TSS2\card_work>mkfc f (Drive number) in the below figure, and push the
"Enter".)
7. Once the "mkcf.bat" is executed, data writing into the Compact flash is started.
8. Upon completion of writing, CHECKSUM is executed. If CHECKSUM value is precisely
matched, "VERYFY OK" appears.
9. Remove the Compact flash from PC.
NOTE
• When removing the Compact flash, be sure to check if data is written as normal
and then remove it according to the precise removing method.
bizhub C350 Field Service Ver.1.0 Mar. 2004
2-4
4036fs2624e0
4036fs2625e0