Konica Minolta Bizhub C350 Service Manual page 183

bizhub C350 Field Service Ver. 2.0 April 2004
C. Dup. Left Margin
Functions • To vary the print start position in the CD direction for each paper source in the 2-
Sided mode.
Use • The Automatic Duplex Unit has been set up.
• The image on the backside of the 2-sided copy deviates in the CD direction.
Adjustment
Width A
Specification
Adjustment • If width A is longer than the specifications, make the setting value smaller than the
Instructions current one.
• If width A is shorter than the specifications, make the setting value greater than the
current one.
Adjustment 1. Call the Tech. Rep. Mode to the screen.
2. Touch "Machine Adjust" → "PRT Area" → "Dup. Left Margin."
Procedure
3. Press the Start key to let the machine produce a test pattern.
4. Check the dimension of width A on the test pattern.
5. If width A falls outside the specified range, change the setting using the Up/Down
key.
6. Press the Start key to let the machine produce a test pattern.
7. Check the dimension of width A on the test pattern on the backside of the copy.
8. If width A is outside the specified range, change the setting again and make a check
again.
9. If width A falls within the specified range, touch "END"
10.Following the same procedure, adjust for all other paper sources. (Use A4 or 8 1/2 ×
11 plain paper for the Manual Bypass Tray.)
•Width A on the test pattern produced should
fall within the following range.
•For measurement, use the image produced
on the backside of the test pattern.
Backside
Specifications : 3.0 ± 0.5 mm
Setting Range: -3.0 mm to +3.0 mm
4036fs3010c0
3-47
TECH. REP. MODE
(in 0.2 mm increments)