Konica Minolta Bizhub C350 Service Manual page 454

Mechanical adjustment
[3]
13. Perform another test print and check the reference deviation.
14. Repeat the adjustment until the reference line falls within the specified range.
15. Tighten the adjustment screw.
16. Repeat steps 1 to 15 similarly for the tray4.
bizhub C350 Field Service Ver.1.0 Mar. 2004
A
4348fs3509c0
[2]
[1]
4348fs3601c0
[4]
4348fs3602c0
3-4
7. Measure the width of printed refer-
ence line A.
Specification: 3.0 mm
8. If the measured width A falls outside
the specified range, enter the correc-
tion value.
9. Produce another test print and check
to see if width A falls within the spec-
ified range.
• If adjustment cannot be completed
only by inputting numeric value,
perform adjustment according to
the following procedure.
10. Slide out the drawer [1] and unload
paper from it.
11. Loosen three screws [2] at the center
of the Paper Lifting Plate.
12. Watching the graduations [3] pro-
vided in the drawer, move the Edge
Guide [4] in the rear.
• If width A is greater than the specified
value, move the Edge Guide toward
the front.
• If width A is smaller than the specified
value, move the Edge Guide toward
the rear.
±
1.0 mm