Setting The Top Of Form (Tof); Temporarily Changing The Print Start Position; Switching Paper Paths - Genicom 930 User Manual

Setting the Top of Form (TOF)

When setting the Top of Form, use the red line (Ê) on the
paper shield as a reference:
1. Make sure the printer is deselected (SEL light off).
Ë
Ê
SEL
LF
SEL
Í
Micro Feed
MENU SHIFT
Down
EXIT GROUP
POWER ALARM
2. Press and hold (Ê), then
SHIFT
* Press
(Ë) to move Top of Form higher (paper
LF
moves down)
* Press
(Ì) to move Top of Form lower
FF/LOAD
(paper moves up)
3. Press (Í) to re-select the printer.
SEL
Ê
Ì
FF/LOAD TEAR PARK QUIET
Micro Feed
TOF
Up
PRINT
ITEM SET
MENU
Temporarily Changing the Print Start
Position
To change the print start position lower for one page only:
1. Press to deselect the printer.
SEL
2. Press to change the position of the Top of Form.
LF
Resetting TOF to the Standard Setting
1. Turn the printer off.
2. Hold +
PARK QUIET/TOF

Switching Paper Paths

To switch from continuous-forms to single-sheet feed:
1. Tear off any printed pages.
2. Press .
PARK
3. Move the paper separator to the single-sheet feed
position.
4. Place the wire feed guide in the paper separator.
5. Move the paper lever to the position marked "TOP."
6. Place a sheet of paper in the paper separator.
while turning the printer back on.
Getting Started E-9