Table of Contents
Advertisement
Loading Paper
PRINT GAP
ADJUSTMENT
WHEEL
1-10
User's Manual
Your printer is designed to use edge-punched (spocket- or pin-fed) fanfold
paper. For a further description of the types of paper that can be used in
your printer, see Appendix B.
CAUTION
Use full-width 14 7 /8-inch (377.8cm) paper
until you are familiar with the printer's setup
and operation.
Printing without paper or using paper too nar-
row for the job will cause the print wires to hit
the striker bar.
Never attempt to move the paper manually by
turning the tractor shafts. This will upset the
belt timing and may damage the tractors.
To load paper in your printer, complete the following steps:
1.
Push the top cover latch in and raise the cover to the open position.
2. Turn the print gap adjustment wheel to the LOAD position by pushing
the top of the wheel towards the rear of the printer until it stops. See
Figure 1-10.
3. Push the paper thickness adjustment lever down to position 1. See
Figure 1-10.
4. Open the top left and right tractor doors. See Figure 1-10
AK04
LEFT AND RIGHT
TRACTOR DOORS
Ftgw-e
1- 10
TOP
COVER
LATCH
Nov 93
Advertisement
Table of Contents
