Oce VarioPrint 1105 User Manual page 519

Adjustment
Procedure
1
Touch [Adjustment] - [02 Finisher Adjustment] - [05 Saddle Stitcher
Adj.].
2
Touch [02 Stapling Paper Width Adjustment] to display the Staple Pa-
per Width Adjustment Screen.
3
Touch the [COPY] tab to display the Copy Screen.
4
Load the desired size of paper to be adjusted on a tray, select
Fold&Staple and then press [Start].
A sample pattern (No. 16) will be output.
5
Check misalignment (a), in which misalignment occurs if the paper
width setting is larger than the actual width, or paper curving (b), in
which a sample set is curved if the paper width setting is smaller than
the actual width has occurred.
6
If the desired result cannot be obtained, touch the [ADJUSTMENT] tab.
7
Touch [Next] or [Back] to select the paper size to be adjusted.
Touching [Next] continuously will change the paper size as follows.
All Size - 11x17 - A3 - B4 - 8.5x14 - A4R - 8.5x11R - B5R - 8x13 -
8.12x13.2 - 8.5x13 - 8.25x13 - 8K - 16KR - 12x18 - A3W - B4W - A4WR
- B5WR - 12x18W - 11x17W - 8.5x11WR - Special
8
Use the touch panel keypad to enter the desired adjustment value, then
touch [Set].
Available range: -20 (wide) to +20 (narrow), 1 step = 0.1 mm
VarioPrint 1105
a
b
13
13-61