Using Large Capacity Stacker Ls-501/Ls-502 - Oce VarioPrint 1105 User Manual

Setting Output Methods
9.5

Using Large Capacity Stacker LS-501/LS-502

The Large Capacity Stacker LS-501/LS-502 has a stacker (on the carriage)
and a secondary (sub) tray, each of which has the following output modes.
Output to the Stacker
- Non-sort:
Non-sort mode simply means that the offset-stacker finisher modes are
not selected. Copies will be stacked upon exit without being offset by
sorted sets.
- Collated:
Collated mode outputs multiple copies of the original set, having each
sorted set offset by 20mm upon exit.
- Uncollated:
Uncollated mode groups together multiple copies of each original and
offsets the sets upon exit.
Combined with the output modes above, you can also choose to output face
up or face down, and output front to back or back to front.
Output to the Secondary (Sub) Tray
- Collated:
Collated mode outputs multiple copies of the original set. No offset out-
put is available.
- Uncollated:
Uncollated mode groups together multiple copies of each original. No
offset output is available.
Combined with the output modes above, you can also choose to output face
up or face down, and output front to back or back to front.
Specifications for Using Large Cpacity Stacker LS-501/LS-502
Stacker
- Paper size: A3, B4, F4, A4, A4R, B5, A5, 12"x18", 11"x17", 8.5"x14",
8.5"x11", 8.5"x11"R, wide size paper (maximum 324 x 460 mm)
- Paper weight: 50 - 244 g/m
- Number of sheets to be stacked:
- 5,000 sheets (A3, B4, F4, A4, A4R, 12"x18", 11"x17", 8.5"x14", 8.5"x11",
8.5"x11"R, wide size paper (maximum 324 x 460 mm)
- 2,000 sheets (B5, A5)
- Different sizes of paper cannot be loaded at the same time.
- To remove paper, open the front door and pull out the base car. If two
units are connected, paper can be removed from one unit while the other
is operating.
VarioPrint 1105
2
9
9-25