Oce VarioPrint 1105 User Manual page 484

13
Procedure
1
Touch [Adjustment] - [02 Finisher Adjustment] - [01 Stapler Position
Adj.].
2
Touch [01 Stapling Center Position Adjustment] to display the Stapling
Centre Position Adjustment Screen.
3
Touch the [COPY] tab to display the Copy Screen.
4
Press [Start]. A sample copy will be output.
5
Use the touch panel keypad to enter the desired adjustment value, then
touch [Set].
Available range: -20 (forward) to +20 (backward), 1 step = 0.1 mm
6
Fold the output sheet in two on the centre to the direction of paper feed
and check misalignment (a) of the stapling centre position.
7
If the test desired result cannot be obtained, touch the [ADJUSTMENT]
tab. Repeat the adjustment steps from 3 to 6 until the desired result is
obtained.
8
Touch [Return] to restore the Stapler Position Adjustment Mode Menu
Screen.
13-26
1
a
2
Adjustment
VarioPrint 1105