Oce VarioPrint 1105 User Manual page 490

13
Procedure
1
Touch [Adjustment] - [02 Finisher Adjustment] - [02 Multi Folder
(Punch) Adj.].
2
Touch [01 Paper Width Adjustment] to display the Paper Width Adjust-
ment Screen.
3
Touch the [COPY] tab to display the Copy Screen.
4
Load the desired size of paper to be adjusted on a tray, specify the set
number to 10, then press [Start]. A sample pattern will be output.
5
Check the diameter of penetrated holes when output sheets are piled
up.
6
If the desired result cannot be obtained, touch the [ADJUSTMENT] tab.
7
Touch [Next] or [Back] to select the paper size to be adjusted.
Touching [Next] continuously will change the paper size as follows.
All - 11x17 - A3 - B4 - 8.5x14 - A4R - 8.5x11R - B5R - 8.5x11 - A4 -
A5R - B5 - A5 - 5.5x8.5 - 8x13 - 8.12x13.2 - 8.5x13 - 8.25x13 - 8K -
16K - 16KR - 12x18
8
Use the touch panel keypad to enter the desired adjustment value, then
touch [Set].
Available range: -20 (wide) to +20 (narrow), 1 step = 0.1 mm
Note
If the setting is too wide, the centre position of punch holes may dislo-
cate. If the setting is too narrow, the position of punch holes may vary.
9
Repeat the adjustment steps from 3 to 8 until the desired result is ob-
tained.
10
Touch [Return] to restore the Multi Folder (Hole-Punch) Adjustment
Mode Menu Screen.
13-32
Adjustment
VarioPrint 1105