Troubleshooting Tips - Oce VarioPrint 1105 User Manual

Troubleshooting
20.6

Troubleshooting Tips

Copier does not operate when sub power switch is on
- Check to be sure power plug is firmly inserted in electrical socket.
- Check to be sure main power switch is ON.
- Check to see if Weekly Timer function is activated. See p. 2-18 for details.
- Check to see if User Authentication is required on the screen. See p. 2-
20 for details.
Copy image is too light
- Manually adjust copy density to darker density.
- Check toner message and add toner, if required.
- Check paper for dampness. Do not leave paper in copier when humidity
is high.
- Check to see if Photo, Text, or Low Contrast mode is required.
- Check the Density shift.
Copy image is too dark
- Manually adjust copy density to lighter density.
- Check to see if Photo, Text, or Low Contrast mode is required.
- Check the Density shift.
Copy image is not clean or shows spots
- Use clean originals since dirt marks may be copied.
- Keep original glass and inner surface of document feeder clean.
- Call for service if "Please call service" is displayed in the message area.
- Check density indicator and lighten if required.
Copy paper mishandles during copying
- Fan copy paper and load it with curl side in proper location. Do not ex-
ceed the tray capacity.
Magnification cannot be changed
- Reduce & Shift is incompatible with magnification.
- Press [Reset] and set desired copying conditions without using Reduce
& Shift.
Duplex modes cannot be selected
Fully close ADF, then select the desired duplex mode again.
VarioPrint 1105
20
20-15