Using Finisher Fs-503 - Oce VarioPrint 1105 User Manual

Setting Output Methods
9.4

Using Finisher FS-503

The Finsiher FS-503 has a primary (main) tray and a secondary (sub) tray,
each of which has the following output modes.
Output to the Primary (Main) Tray:
- Non-sort:
Non-sort mode simply means that the offset-stacker finisher modes are
not selected. Copies will be stacked upon exit without being offset by
sorted sets.
- Collated:
Collated mode outputs multiple copies of the original set, having each
sorted set offset by 30 mm upon exit.
- Uncollated:
Uncollated mode groups together multiple copies of each original and
offsets the sets by 30 mm upon exit.
- Staple:
Staple mode offsets and staples each sorted set.
Combined with the output modes above except staple mode, you can also
choose to output face up or face down, and output front to back or back to
front.
Non-sort
VarioPrint 1105
Staple
2 staples
Offset by 30mm
1 oblique
staple
Example:
Make 3 copied sets
from 4 original sheets
Collated Uncollated
Offset by 30mm
9
9-15