Tandem Setting - Oce VarioPrint 1105 User Manual

16

16.2.9 05 Tandem Setting

The following settings are provided for the tandem output mode, which is
specified on the master machine and used to distribute plural number of print
quantity among two machines (master and tandem).
01 Tandem Machine One Time Data Read: On/Off
Select [Off] so that both master and tandem machines start printing at the
same time, while the master machine continues scanning the image data.
Select [On] so that the tandem machine will be kept waiting till it receives all
the image data transmitted from the master machine, while the master ma-
chine already started to print.
02 Tandem Machine Wait/Proof: Permit/Prohibit
Select [Prohibit] so that the master machine starts proofcopying without
transmitting the image data to the tandem machine. In this case, the tandem
machine receives the data and starts printing when normal printing job has
been started.
Select [Permit] so that the master machine transmits the scanned image data
to the tandem machine and both machines start proofcopying at the same
time.
03 Tandem Machine Shift Data Setting: Master Machine Shift data/Tan-
dem Machine Shift data
Select [Master Machine Shift data] so that the tandem machine uses the
same shift value used on the master machine.
Select [Tandem Machine Shift data] so that the tandem machine independ-
ently uses the shift value specified on it. If Prohibit is selected in 02 Tandem
Machine Wait/Proof, the shift value specified on the tandem machine cannot
be used because the master machine transmits the scanned image data
which already reflect its shift value.
04 Tandem setting after JOB completion: Continue/Release
Select [Continue] so that the tandem mode remains to be specified after the
tandem printing job is completed.
Select [Release] so that the tandem mode will be released after the tandem
printing job is completed.
16-34
User Setting
VarioPrint 1105