Oce VarioPrint 1105 User Manual page 990

20
Copying does not begin after pressing [Start]
- Close Front door and left side door of main body.
- Insert or adjust the appropriate paper tray for paper size selected.
- Be sure the print quantity is entered.
- Close Finisher door/Folding unit door/Large capacity stacker door com-
pletely.
Copying does not resume after mishandled paper is removed
Check copier diagram on touch panel for additional indications of mishan-
dled paper.
Copy quality is poor
- Check paper for dampness, and replace it if necessary.
- Contact your service representative.
Using user authentication, copies cannot be made after password is en-
tered
- Check to see if the message "Copy limit reached" is displayed.
- Contact the machine manager to reset limit.
The original paper is mishandled or skewed in the document feeder
- Originals should conform to the recommended size and weight.
- Be sure originals are not stapled.
- Align originals evenly in the ADF.
- Check to make sure paper guides meet the width of mixed size originals.
ADF cannot be used after [Reset] is pressed
- Fully close ADF.
- Originals should conform to the recommended size and weight.
- Position originals properly in the ADF.
- Set to use ADF in the Initial Setting.
Finisher/Folding unit does not operate
- Check for a paper misfeed and remove it, as required.
- Properly close finisher door/Folding unit door.
Add toner message is displayed
New toner supply is needed. Follow instructions for adding toner.
Call for PM is displayed in message area
Contact your service representative for Preventive Maintenance.
20-16
Troubleshooting
VarioPrint 1105