Oce VarioPrint 1105 User Manual page 486

13
Procedure
1
Touch [Adjustment] - [02 Finisher Adjustment ]- [01 Stapler Position
Adj.].
2
Touch [02 Paper Width Adjustment] to display the Paper Width Adjust-
ment Screen.
3
Touch [Straight Mode] or [Staple Mode] to select the adjustment mode.
4
Touch the [COPY] tab to display the Copy Screen.
5
Load the desired size of paper to be adjusted on a tray.
6
If [Straight Mode] has been selected in step 3, press [Start].
If [Staple Mode] has been selected in step 3, touch [Staple] and then
press [Start].
7
Open the finisher door, then pull out
the stapler unit.
- Check the clearance between fix-
ing plates and output paper.
Note
When paper length is 239 mm or longer, the stapler unit cannot be pulled
out. In this case, remove the paper before pulling out the stapler unit, then
return the paper to the original position.
13-28
Adjustment
VarioPrint 1105