Configuring Gateways For The Dhcp Client - H3C S5600 Series Operation Manual

Operation Manual – DHCP
H3C S5600 Series Ethernet Switches
Follow these steps to configure WINS servers for the DHCP client:
Enter system view
Enter DHCP address pool
view
Configure WINS server
addresses for DHCP
clients
Configure DHCP clients to
be of a specific NetBIOS
node type
Note:
If b-node is specified for the client, you don't need to specify any WINS server address.

2.4.8 Configuring Gateways for the DHCP Client

Gateways are necessary for DHCP clients to access servers/hosts outside the current
network segment. After you configure gateway addresses on a DHCP server, the
DHCP server provides the gateway addresses to DHCP clients as well while assigning
IP addresses to them.
You can configure gateway addresses for global address pools on a DHCP server.
Currently, you can configure up to eight gateway addresses for a DHCP address pool.
Follow these steps to configure gateways for the DHCP client:
Enter system view
Enter DHCP address pool
view
Configure gateway
addresses for DHCP
clients
To do...
system-view
dhcp server ip-pool
pool-name
nbns-list
ip-address&<1-8>
netbios-type { b-node |
h-node | m-node |
p-node }
To do...
system-view
dhcp server ip-pool
pool-name
gateway-list
ip-address&<1-8>
Chapter 2 DHCP Server Configuration
Use the command...
Use the command...
2-13
Remarks
—
—
Required
By default, no WINS
server address is
configured.
Optional
By default, no NetBIOS
node type of the DHCP
client is specified.
Remarks
—
—
Required
By default, no gateway
address is configured.