Tftp Configuration Example - H3C S5600 Series Operation Manual

Operation Manual – FTP-SFTP-TFTP
H3C S5600 Series Ethernet Switches
Note:
The specified interface must be an existing one; otherwise a prompt appears to
show that the configuration fails.
The value of the ip-address argument must be an IP address on the device where
the configuration is performed, and otherwise a prompt appears to show that the
configuration fails.
The source interface/source IP address set for one connection is prior to the fixed
source interface/source IP address set for each connection. That is, for a
connection between a TFTP client and a TFTP server, if you specify the source
interface/source IP address only used for the connection this time, and the specified
source interface/source IP address is different from the fixed one, the former will be
used for the connection this time.
You may specify only one source interface or source IP address for the TFTP client
at one time. That is, only one of the commands tftp source-interface and tftp
source-ip can be effective at one time. If both commands are configured, the one
configured later will overwrite the original one.

2.2.2 TFTP Configuration Example

I. Network requirements
A switch operates as a TFTP client and a PC as the TFTP server. The application
named switch.bin is stored on the PC. Download it (switch.bin) to the switch through
TFTP, and use the boot boot-loader command to specify switch.bin as the
application for next startup. Reboot the switch to upload the configuration file named
config.cfg to the work directory on the PC to back up the configuration file.
The TFTP working directory is configured on the TFTP server.
Configure the IP addresses of a VLAN interface on the switch and the PC as
1.1.1.1 and 2.2.2.2 respectively. The port through which the switch connects with
the PC belongs to the VLAN.
II. Network diagram
Figure 2-1 Network diagram for TFTP configurations
III. Configuration procedure
1) Configure the TFTP server (PC)
2-4
Chapter 2 TFTP Configuration