H3C S5600 Series Operation Manual page 1119

Operation Manual – System Maintenance and Debugging
H3C S5600 Series Ethernet Switches
Bootrom updating.....................................done!
Note:
If the HyperTerminal's baudrate is not reset to 9600 bps, the system prompts "Your
baudrate should be set to 9600 bps again! Press enter key when ready".
You need not reset the HyperTerminal's baudrate and can skip the last step if you
have chosen 9600 bps. In this case, the system upgrades the Boot ROM
automatically and prompts "Bootrom updating now.....................................done!".
III. Loading host software
Follow these steps to load the host software:
Step 1: Select <1> in BOOT Menu and press <Enter>. The system displays the
following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
Step 2: Enter 3 in the above menu to load the host software by using XModem.
The subsequent steps are the same as those for loading the Boot ROM, except that the
system gives the prompt for host software loading instead of Boot ROM loading.
Note:
You can also use the xmodem get command to load host software through the
Console port (of AUX type). The load procedures are as follows (assume that the PC is
connected to the Console port of the switch, and logs onto the switch through the
Console port):
Step 1: Execute the xmodem get command in user view. In this case, the switch is
ready to receive files.
Step 2: Enable the HyperTerminal on the PC, and configure XModem as the transfer
protocol, and configure communication parameters on the Hyper Terminal the same as
that on the Console port.
Step 3: Choose the file to be loaded to the switch, and then start to transmit the file.
Chapter 1 Boot ROM and Host Software
1-8
Loading