H3C S5600 Series Operation Manual page 851

Operation Manual – QoS-QoS Profile
H3C S5600 Series Ethernet Switches
Configure the current port
as a source mirroring port
Quit to system view
Configure
the
specified
port as the
destination
mirroring
port
Note:
For information about the mirroring-group monitor-port command and the
monitor-port command, refer to the part talking about mirroring.
III. Configuration example
# Assume that GigabitEthernet 1/0/1 is connected to the 10.1.1.0/24 network segment.
Duplicate the packets from network segment 10.1.1.0/24 to the destination mirroring
port GigabitEthernet 1/0/4.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface GigabitEthernet1/0/4
[Sysname-GigabitEthernet1/0/4] monitor-port
[Sysname-GigabitEthernet1/0/4] quit
[Sysname] interface GigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1]
monitor-interface
To do...
mirrored-to inbound
acl-rule
{ monitor-interface |
cpu }
quit
mirroring-group group-id
In system
monitor-port
view
monitor-port-id
interface interface-type
interface-number
In Ethernet
port view
monitor-port
Use the command...
mirrored-to
1-29
Chapter 1 QoS Configuration
Remarks
Required
Omit the following steps if
you redirect traffic to the
CPU.
Proceed to the following
steps if you redirect traffic
to a port.
—
Required
Use either approach.
inbound ip-group 2000