Setting To Output System Information To The Console - H3C S5600 Series Operation Manual

Operation Manual – Information Center
H3C S5600 Series Ethernet Switches
Set the time zone for the
system
Enter system view
Set the
time stamp
format in
the output
direction of
the
information
center to
date
Set to display the UTC time
zone in the output
information of the
information center

1.2.4 Setting to Output System Information to the Console

I. Setting to output system information to the console
Follow these steps to set to output system information to the console:
Enter system view
Enable the information
center
Enable system
information output to the
console
Configure the output rules
of system information
To do...
clock timezone
zone-name { add |
minus } time
system-view
Log host info-center timestamp
direction loghost date
info-center timestamp
Non log host
{ log | trap | debugging }
direction
date
info-center timestamp
utc
To do...
system-view
info-center enable
info-center console
channel
{ channel-number |
channel-name }
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
Use the command...
Use the command...
1-10
Chapter 1 Information Center
Remarks
Required
By default, UTC time
zone is set for the
system.
—
Required
Use either command
Required
By default, no UTC time
zone is displayed in the
output information
Remarks
—
Optional
Enabled by default.
Optional
By default, the switch
uses information channel
0 to output
log/debugging/trap
information to the
console.
Optional
Refer to Table 1-4 for the
default output rules of
system information.