Vlan-Vpn Configuration; Vlan-Vpn Configuration Task List; Enabling The Vlan-Vpn Feature For A Port; Configuring The Inner-To-Outer Tag Priority Replicating And Mapping Feature - H3C S5600 Series Operation Manual

Operation Manual – VLAN-VPN
H3C S5600 Series Ethernet Switches
Refer to QoS-QoS Profile part for information about priority.

1.2 VLAN-VPN Configuration

1.2.1 VLAN-VPN Configuration Task List

Complete the following tasks to configure VLAN-VPN:

Enabling the VLAN-VPN Feature for a Port

Configuring the Inner-to-Outer Tag Priority Replicating and
Mapping Feature
Caution:
As IRF fabric is mutually exclusive with VLAN-VPN, make sure that IRF fabric is
disabled on the switch before performing any of the configurations listed in the above
table. For information about IRF fabric, refer to IRF Fabric Configuration in this manual.
1.2.2 Enabling the VLAN-VPN Feature for a Port
Follow these steps to enable the VLAN-VPN feature for a port:
Enter system view
Enter Ethernet port
view
Enable the VLAN-VPN
feature on the port
1.2.3 Configuring the Inner-to-Outer Tag Priority Replicating and Mapping
Feature
Make sure that the VLAN-VPN feature is enabled on a port before configuring the
inner-to-outer tag priority replicating and mapping feature.
Follow these steps to configure the inner-to-outer tag priority replicating and mapping
feature:
To do... Use the command...
system-view
interface interface-type
interface-number
vlan-vpn enable
Task
1-3
Chapter 1 VLAN-VPN Configuration
Remarks
Required
Optional
Remarks
—
—
Required
By default, the VLAN-VPN
feature is disabled on a port.