Setting The Poe Mode On A Port; Configuring The Pd Compatibility Detection Function - H3C S5600 Series Operation Manual

Operation Manual – PoE-PoE Profile
H3C S5600 Series Ethernet Switches
close to its full load and a new PD is now added to port A, the switch just gives a
prompt that a new PD is added and will not supply power to this new PD.
After the PoE feature is enabled on the port, perform the following configuration to set
the PoE management mode and PoE priority of a port.
Follow these steps to set the PoE management mode and PoE priority of a port:
Enter system view
Set the PoE management
mode for the switch
Enter Ethernet port view
Se the PoE priority of a
port

1.2.5 Setting the PoE Mode on a Port

PoE mode of a port falls into two types, signal mode and spare mode.
Signal mode: DC power is carried over the data pairs (1,2,3,and 6) of category-3/5
twisted pairs.
Spare mode: DC power is carried over the spare pairs (4,5,7,and 8) of
category-3/5 twisted pairs.
Currently, S5600 series Ethernet switches do not support the spare mode.
After the PoE feature is enabled on the port, perform the following configuration to set
the PoE mode on a port.
Follow these steps to set the PoE mode on a port:
Enter system view
Enter Ethernet port view
Set the PoE mode on the
port to signal

1.2.6 Configuring the PD Compatibility Detection Function

After the PD compatibility detection function is enabled, the switch can detect the PDs
that do not conform to the 802.3af standard and supply power to them.
To do...
system-view
poe power-management
{ auto | manual }
interface interface-type
interface-number
poe priority { critical |
high | low }
To do...
system-view
interface interface-type
interface-number
poe mode signal
Use the command...
Use the command...
1-5
Chapter 1 PoE Configuration
Remarks
—
Required
auto by default.
—
Required
low by default.
Remarks
—
—
Optional
signal by default.