Chapter 2 Ipv6 Application Configuration; Introduction To Ipv6 Application; Configuring Ipv6 Application; Ipv6 Ping - H3C S5600 Series Operation Manual

Hide thumbs Also See for H3C S5600 Series:

Table of Contents

Operation Manual – IPv6 Management

H3C S5600 Series Ethernet Switches

Chapter 2 IPv6 Application Configuration

When configuring IPv6 application, go to these sections for information you are

interested in:

IPv6 Application Configuration Example

Troubleshooting IPv6 Application

2.1 Introduction to IPv6 Application

IPv6 are supporting more and more applications. Most of IPv6 applications are the

same as those of IPv4. The applications supported on H3C S5600 Series Ethernet

Switches are:

2.2 Configuring IPv6 Application

The ping ipv6 command is commonly used for testing the reachability of a host. This

command sends an ICMPv6 message to the destination host and records the time for

the response message to be received. For details about the ping command, refer to

System Maintenance and Debugging Operation in this manual.

After you execute the ping ipv6 command, you can press Ctrl+C to terminate the ping

Follow these steps to ping IPv6:

Use the command...

ping ipv6 [ -a source-ipv6 | -c

count | -m interval | -s packet-size |

-t timeout ]* remote-system [ -i

interface-type interface-number ]

Chapter 2 IPv6 Application Configuration

Available in any view

Table of Contents