Displaying Rmon; Rmon Configuration Example - H3C S5600 Series Operation Manual

Operation Manual – SNMP-RMON
H3C S5600 Series Ethernet Switches

2.3 Displaying RMON

Display RMON statistics
Display RMON history
information
Display RMON alarm
information
Display extended RMON
alarm information
Display RMON events
Display RMON event logs

2.4 RMON Configuration Example

I. Network requirements
The switch to be tested is connected to a remote NMS through the Internet.
Ensure that the SNMP agents are correctly configured before performing RMON
configuration.
Create an entry in the extended alarm table to monitor the information of statistics
on the Ethernet port, if the change rate of which exceeds the set threshold, the
alarm events will be triggered.
II. Network diagram
Figure 2-1 Network diagram for RMON configuration
III. Configuration procedures
# Add the statistics entry numbered 1 to take statistics on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] rmon statistics 1
[Sysname-GigabitEthernet1/0/1] quit
# Add the event entries numbered 1 and 2 to the event table, which will be triggered by
the following extended alarm.
To do...
display rmon statistics [ interface-type
interface-number | unit unit-number ]
display rmon history [ interface-type
interface-number | unit unit-number ]
display rmon alarm [ entry-number ]
display rmon prialarm
[ prialarm-entry-number ]
display rmon event [ event-entry ]
display rmon eventlog [ event-entry ]
Use the command...
2-5
Chapter 2 RMON Configuration
Remarks
Available in
any view.