H3C S5600 Series Operation Manual page 880

Operation Manual – Mirroring
H3C S5600 Series Ethernet Switches
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk permit vlan 10
[Sysname-GigabitEthernet1/0/1] quit
# Configure GigabitEthernet 1/0/2 as the trunk port, allowing packets of VLAN 10 to
pass.
[Sysname] interface GigabitEthernet 1/0/2
[Sysname-GigabitEthernet1/0/2] port link-type trunk
[Sysname-GigabitEthernet1/0/2] port trunk permit vlan 10
3) Configure the destination switch (Switch C)
# Create remote destination mirroring group 1.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-destination
# Configure VLAN 10 as the remote-probe VLAN.
[Sysname] vlan 10
[Sysname-vlan10] remote-probe vlan enable
[Sysname-vlan10] quit
# Configure the destination port and remote-probe VLAN for the remote destination
mirroring group.
[Sysname] mirroring-group 1 monitor-port GigabitEthernet 1/0/2
[Sysname] mirroring-group 1 remote-probe vlan 10
# Configure GigabitEthernet 1/0/1 as the trunk port, allowing packets of VLAN 10 to
pass.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk permit vlan 10
[Sysname-GigabitEthernet1/0/1] quit
# Display configuration information about remote destination mirroring group 1.
[Sysname] display mirroring-group 1
mirroring-group 1:
type: remote-destination
status: active
monitor port: GigabitEthernet1/0/2
remote-probe vlan: 10
After the configurations, you can monitor all packets sent from Department 1 and 2 on
the data detection device.
Chapter 1 Mirroring Configuration
1-13