H3C S5600 Series Operation Manual page 345

Operation Manual – Routing Protocol
H3C S5600 Series Ethernet Switches
Note:
When configuring the values of RIP timers, you should take network performance into
consideration and perform consistent configuration on all routers running RIP to avoid
unnecessary network traffic and network route oscillation.
II. Configuring split horizon
Follow these steps to configure split horizon:
To do...
Enter system view
Enter interface view
Enable split horizon
Note:
Split horizon cannot be disabled on a point-to-point link.
III. Configuring RIP-1 packet zero field check
Follow these steps to configure RIP-1 packet zero field check:
Enter system view
Enter RIP view
Enable the check of the must be
zero field in RIP-1 packets
Note:
Some fields in a RIP-1 packet must be 0, and they are known as must be zero field.
For RIP-1, the must be zero field is checked for incoming packets, and those RIP-1
packets with this field being nonzero will not be processed.
Use the command...
system-view
interface interface-type
interface-number
rip split-horizon
To do...
3-10
Use the command...
system-view
rip
checkzero
Chapter 3 RIP Configuration
Remarks
—
—
Required
Enabled by default
Remarks
—
—
Required
Enabled by default