Operation Manual – Multicast
H3C S5600 Series Ethernet Switches
Configure to filter the
registration packets
from RP to DR
Caution:
Only the registration packets matching the permit command of ACLs can be accepted.
When an invalid ACL is defined, RP will reject all the registration packets.
4.3.5 Disabling RPT-to-SPT Switchover
Initially, a PIM-SM-enabled multicast device forwards multicast packets through an RPT.
By default, the last-hop switch initiates an RPT-to-SPT switchover process. You can
also disable RPT-to-SPT switchover through the configuration.
Follow these steps to disable RPT-to-SPT switchover:
Enter system view
Enter PIM view
Disable RPT-to-SPT
switchover
Note:
Typically, you need to configure the above-mentioned parameters on the receiver-side
DR and the RP only. Since both the DR and RP are elected, however, you should carry
out these configurations on the routers that may win DR election and on the C-RPs that
may win RP election.
4.4 Configuring Common PIM Parameters
Complete the following tasks to configure common PIM parameters:
To do...
Use the command...
register-policy
acl-number
To do...
system-view
pim
spt-switch-threshold
infinity [ group-policy
acl-number [ order
order-value ] ]
Use the command...
4-17
Chapter 4 PIM Configuration
Remarks
Required
By default, the switch does
not filter the registration
packets from DR.
Remarks
—
—
Optional
By default, the device
switches to the SPT
immediately after it
receives the first multicast
packet from the RPT.