Configuring Root Bridge - H3C S5600 Series Operation Manual

Operation Manual – MSTP
H3C S5600 Series Ethernet Switches

1.3 Configuring Root Bridge

Complete the following tasks to configure the root bridge:
Enabling MSTP
Configuring an MST Region
Specifying the Current Switch as a
Root Bridge/Secondary Root Bridge
Configuring the Bridge Priority of the
Current Switch
Configuring How a Port Recognizes
and Sends MSTP Packets
Configuring the MSTP Operation Mode
Configuring the Maximum Hop Count
of an MST Region
Configuring the Network Diameter of
the Switched Network
Configuring the MSTP Time-related
Parameters
Configuring the Timeout Time Factor
Configuring the Maximum Transmitting
Rate on the Current Port
Configuring the Current Port as an
Edge Port
Specifying Whether the Link
Connected to a Port Is Point-to-point
Link
Task
1-19
Chapter 1 MSTP Configuration
Remarks
Required
To prevent network topology jitter caused
by other related configurations, you are
recommended to enable MSTP after other
related configurations are performed.
Required
Required
Optional
The priority of a switch cannot be changed
after the switch is specified as the root
bridge or a secondary root bridge.
Optional
Optional
Optional
Optional
The default value is recommended.
Optional
The default values are recommended.
Optional
Optional
The default value is recommended.
Optional
Optional