Configuring Igmp Proxy; Removing Joined Igmp Groups From An Interface - H3C S5600 Series Operation Manual

Operation Manual – Multicast
H3C S5600 Series Ethernet Switches

3.2.8 Configuring IGMP Proxy

Follow these steps to configure IGMP proxy:
Enter system view
Enter VLAN interface view
Configure IGMP proxy
Caution:
You must enable the PIM protocol on the interface before configuring the igmp
proxy command. Otherwise, the IGMP Proxy feature does not take effect.
One interface cannot serve as the proxy interface for two or more interfaces.
Generally, an interface serving as an IGMP querier cannot act as an IGMP proxy
interface. If it is necessary to configure an IGMP querier interface as an IGMP proxy
interface, you must configure the port that belongs to the proxy interface and
connects to the upstream multicast device as a static router port. For details, see
Configuring a Static Router

3.2.9 Removing Joined IGMP Groups from an Interface

You can remove all the joined multicast groups from a particular interface or all
interfaces of the switch, or remove a particular multicast group address or group
address range from a particular interface or all interfaces.
Follow these steps to remove joined multicast groups from one or all interfaces:
Remove the specified
group or all groups from
the specified interface or
all interfaces
To do...
system-view
interface Vlan-interface
interface-number
igmp proxy Vlan-interface
interface-number
Port.
To do...
reset igmp group { all |
interface interface-type
interface-number { all |
group-address
[ group-mask ] } }
Use the command...
Use the command...
3-12
Chapter 3 IGMP Configuration
Remarks
—
—
Required
Disabled by default
Remarks
This command is
available in user view.