H3C S5600 Series Operation Manual page 1061

Operation Manual – FTP-SFTP-TFTP
H3C S5600 Series Ethernet Switches
Note:
The specified interface must be an existing one. Otherwise a prompt appears to
show that the configuration fails.
The value of the ip-address argument must be an IP address on the device where
the configuration is performed. Otherwise a prompt appears to show that the
configuration fails.
You can specify only one source interface or source IP address for the FTP at one
time. That is, only one of the commands ftp-server source-interface and
ftp-server source-ip can be valid at one time. If you execute both of them, the new
setting will overwrite the original one.
If the switch (FTP server) is the command switch or member switch in a cluster, do
not use the ftp-server source-ip command to specify the private IP address of the
cluster as the source IP address of the FTP server. Otherwise, FTP does not take
effect.
V. Disconnecting a specified user
On the FTP server, you can disconnect a specified user from the FTP server to secure
the network.
Follow these steps to disconnect a specified user:
Enter system view
On the FTP server,
disconnect a specified
user from the FTP server
Note:
With an H3C S5600 series Ethernet switch acting as the FTP server, if a network
administrator attempts to disconnect a user that is uploading/downloading data to/from
the FTP server the S5600 Ethernet switch will disconnect the user after the data
transmission is completed.
VI. Configuring the banner for an FTP server
Displaying a banner: With a banner configured on the FTP server, when you access the
FTP server through FTP, the configured banner is displayed on the FTP client. Banner
falls into the following two types:
To do...
system-view
ftp disconnect
user-name
Chapter 1 FTP and SFTP Configuration
Use the command...
1-6
Remarks
—
Required