H3C S5600 Series Operation Manual page 920

Operation Manual – Cluster
H3C S5600 Series Ethernet Switches
[Sysname] ntdp hop 2
# Set the delay for a member device to forward topology collection requests to 150 ms.
[Sysname] ntdp timer hop-delay 150
# Set the delay for a member device port to forward topology collection requests to 15
ms.
[Sysname] ntdp timer port-delay 15
# Set the interval between collecting topology information to 3 minutes.
[Sysname] ntdp timer 3
# Enable the cluster function.
[Sysname] cluster enable
# Enter cluster view.
[Sysname] cluster
[Sysname-cluster]
# Configure a private IP address pool for the cluster. The IP address pool contains six
IP addresses, starting from 172.16.0.1.
[Sysname-cluster] ip-pool 172.16.0.1 255.255.255.248
# Name and build the cluster.
[Sysname-cluster] build aaa
[aaa_0.Sysname-cluster]
# Add the attached two switches to the cluster.
[aaa_0.Sysname-cluster] add-member 1 mac-address 000f-e201-0011
[aaa_0.Sysname-cluster] add-member 17 mac-address 000f-e201-0012
# Set the holdtime of member device information to 100 seconds.
[aaa_0.Sysname-cluster] holdtime 100
# Set the interval between sending handshake packets to 10 seconds.
[aaa_0.Sysname-cluster] timer 10
# Configure VLAN-interface 2 as the network management interface.
[aaa_0.Sysname-cluster] nm-interface Vlan-interface 2
# Configure the shared FTP server, TFTP server, logging host and SNMP host for the
cluster.
[aaa_0.Sysname-cluster] ftp-server 63.172.55.1
[aaa_0.Sysname-cluster] tftp-server 63.172.55.1
[aaa_0.Sysname-cluster] logging-host 69.172.55.4
[aaa_0.Sysname-cluster] snmp-host 69.172.55.4
3) Perform the following operations on the member devices (taking one member as
an example)
1-26
Chapter 1 Cluster