Remote Boot Rom And Software Loading - H3C S5600 Series Operation Manual

Operation Manual – System Maintenance and Debugging
H3C S5600 Series Ethernet Switches
Switch IP address
Server IP address
FTP User Name
FTP User Password
Step 5: Press <Enter>. The system displays the following information:
Are you sure to update your bootrom?Yes or No(Y/N)
Step 6: Enter Y to start file downloading or N to return to the Boot ROM update menu. If
you enter Y, the system begins to download and update the program. Upon completion,
the system displays the following information:
Loading........................................done
Bootrom updating..........done!
Loading host software
Follow these steps to load the host software:
Step 1: Select <1> in BOOT Menu and press <Enter>. The system displays the
following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
Enter 2 in the above menu to download the host software using FTP.
The subsequent steps are the same as those for loading the Boot ROM, except for that
the system gives the prompt for host software loading instead of Boot ROM loading.
Caution:
When loading the Boot ROM and host software using FTP through BOOT menu, you
are recommended to use the PC directly connected to the device as FTP server to
promote upgrading reliability.

1.3 Remote Boot ROM and Software Loading

If your terminal is not directly connected to the switch, you can telnet to the switch, and
use FTP or TFTP to load the Boot ROM and host software remotely.
Chapter 1 Boot ROM and Host Software
:10.1.1.2
:10.1.1.1
:Switch
:abc
1-12
Loading