Displaying And Maintaining Port Mirroring; Mirroring Configuration Examples; Local Port Mirroring Configuration Example - H3C S5600 Series Operation Manual

Operation Manual – Mirroring
H3C S5600 Series Ethernet Switches
Only an existing static VLAN can be configured as the remote-probe VLAN. To
remove a remote-probe VLAN, you need to restore it to a normal VLAN first. A
remote port mirroring group gets invalid if the corresponding remote port mirroring
VLAN is removed.

1.3 Displaying and Maintaining Port Mirroring

To do...
Display port
mirroring
configuration

1.4 Mirroring Configuration Examples

1.4.1 Local Port Mirroring Configuration Example

I. Network requirements
The departments of a company connect to each other through S5600 Ethernet
switches:
Research and Development (R&D) department is connected to Switch C through
GigabitEthernet 1/0/1.
Marketing department is connected to Switch C through GigabitEthernet 1/0/2.
Data detection device is connected to Switch C through GigabitEthernet 1/0/3
The administrator wants to monitor the packets received on and sent from the R&D
department and the marketing department through the data detection device.
Use the local port mirroring function to meet the requirement. Perform the following
configurations on Switch C.
Configure GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 as mirroring source
ports.
Configure GigabitEthernet 1/0/3 as the mirroring destination port.
Use the command...
display mirroring-group { group-id
| all | local | remote-destination |
remote-source }
1-9
Chapter 1 Mirroring Configuration
Remarks
Available in any view