H3C S5600 Series Operation Manual page 908

Operation Manual – Cluster
H3C S5600 Series Ethernet Switches
Configure the interval to
collect topology
information periodically
Quit system view
Launch topology
information collection
manually
VI. Enabling the cluster function
Follow these steps to enable the cluster function:
Enter system view
Enable the cluster
function globally
VII. Configuring cluster parameters
The establishment of a cluster and the related configuration can be accomplished in
manual mode or automatic mode, as described below.
1) Establishing a cluster and configuring cluster parameters in manual mode
Follow these steps to establish a cluster and configure cluster parameters in manual
mode:
Enter system view
Specify the management
VLAN
Enter cluster view
Configure a IP address
pool for the cluster
Build a cluster
To do...
ntdp timer
interval-in-minutes
quit
ntdp explore
To do...
system-view
cluster enable
To do...
system-view
management-vlan
vlan-id
cluster
ip-pool
administrator-ip-address
{ ip-mask |
ip-mask-length }
build name
Use the command...
Use the command...
Use the command...
1-14
Chapter 1 Cluster
Remarks
Optional
By default, the topology
collection interval is one
minute.
—
Optional
Remarks
—
Required
By default, the cluster
function is enabled.
Remarks
—
Required
By default, VLAN 1 is
used as the management
VLAN.
—
Required
Required
name: Cluster name.