Configuring Basic Snmp Functions - H3C S5600 Series Operation Manual

Hide thumbs Also See for H3C S5600 Series:

Table of Contents

Operation Manual – SNMP-RMON

H3C S5600 Series Ethernet Switches

MIB describes the hierarchical architecture of the tree and it is the set defined by the

standard variables of the monitored network devices. In the above figure, the managed

object B can be uniquely identified by a string of numbers {1.2.1.1}. The number string

is the object identifier (OID) of the managed object.

The common MIBs supported by switches are listed in

Table 1-1 Common MIBs

MIB attribute

1.2 Configuring Basic SNMP Functions

SNMPv3 configuration is quite different from that of SNMPv1 and SNMPv2c. Therefore,

the configuration of basic SNMP functions is described by SNMP versions, as listed in

the following two tables.

Switches now support configuring SNMPv3 users by using the Advanced Encryption

Standard (AES), which is the new encryption standard in place of Data Encryption

Standard (DES).

Follow these steps to configure basic SNMP functions (SNMPv1 and SNMPv2c):

MIB II based on TCP/IP

network device

Ethernet MIB

IPV6 ADDRESS MIB

MIRRORGROUP MIB

Device management

Interface management

Chapter 1 SNMP Configuration

Table of Contents