Tftp Configuration; Tftp Configuration: A Switch Operating As A Tftp Client - H3C S5600 Series Operation Manual

Operation Manual – FTP-SFTP-TFTP
H3C S5600 Series Ethernet Switches
Note:
Before performing TFTP-related configurations, you need to configure IP addresses for
the TFTP client and the TFTP server, and make sure a route exists between the two.

2.2 TFTP Configuration

Complete the following tasks to configure TFTP:
TFTP Configuration: A
Switch Operating as a
TFTP Client
TFTP server configuration

2.2.1 TFTP Configuration: A Switch Operating as a TFTP Client

I. Basic configurations on a TFTP client
By default a switch can operate as a TFTP client. In this case you can connect the
switch to the TFTP server to perform TFTP-related operations (such as
creating/removing a directory) by executing commands on the switch.
Follow these steps to perform basic configurations on a TFTP client:
Download a file from a
TFTP server
Upload a file to a TFTP
server
Enter system view
Set the file transmission
mode
Specify an ACL rule used
by the specified TFTP
client to access a TFTP
server
Task
Basic configurations on a
TFTP client
Specifying the source
interface or source IP
address for an FTP client
For details, see the
corresponding manual
To do...
tftp tftp-server get
source-file [ dest-file ]
tftp tftp-server put
source-file [ dest-file ]
system-view
tftp { ascii | binary }
tftp-server acl
acl-number
Use the command...
2-2
Chapter 2 TFTP Configuration
Remarks
—
Optional
—
Remarks
Optional
Optional
—
Optional
Binary by default.
Optional
Not specified by default.