Enabling Logging For Network Management - H3C S5600 Series Operation Manual

Operation Manual – SNMP-RMON
H3C S5600 Series Ethernet Switches
Follow these steps to configure extended trap function:
Enter system view
Configure the extended
trap function

1.4 Enabling Logging for Network Management

Follow these steps to enable logging for network management:
Enter system view
Enable logging for
network management
Note:
When SNMP logging is enabled on a device, SNMP logs are output to the
information center of the device. With the output destinations of the information
center set, the output destinations of SNMP logs will be decided.
The severity level of SNMP logs is informational, that is, the logs are taken as
general prompt information of the device. To view SNMP logs, you need to enable
the information center to output system information with informational level.
For detailed description on system information and information center, refer to the
Information Center Configuration part in this manual.
To do... Use the command...
system-view
snmp-agent trap
ifmib link extended
To do...
system-view
snmp-agent log
{ set-operation |
get-operation | all }
Use the command...
1-8
Chapter 1 SNMP Configuration
Remarks
—
Optional
By default, the
linkUp/linkDown trap adopts
the standard format defined
in IF-MIB. For details, refer
to RFC 1213.
Remarks
—
Optional
Disabled by default.