H3C S5600 Series Operation Manual page 1206

Operation Manual – HWPing
H3C S5600 Series Ethernet Switches
II. Network diagram
Figure 1-9 Network diagram for the Udpprivate test
III. Configuration procedure
Configure HWPing Server (Switch B):
# Enable the HWPing server and configure the IP address and port to listen on.
<Sysname> system-view
[Sysname] hwping-server enable
[Sysname] hwping-server udpecho 10.2.2.2 8000
Configure HWPing Client (Switch A):
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create a HWPing test group, setting the administrator name to administrator and
test tag to udpprivate.
[Sysname] Hwping administrator udpprivate
# Configure the test type as udpprivate.
[Sysname-hwping-administrator-udpprivate] test-type udpprivate
# Configure the IP address of the HWPing server as 10.2.2.2.
[Sysname-hwping-administrator-udpprivate] destination-ip 10.2.2.2
# Configure the destination port on the HWPing server.
[Sysname-hwping-administrator-udpprivate] destination-port 8000
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-udpprivate] count 10
# Set the probe timeout time to 5 seconds.
[Sysname-hwping-administrator-udpprivate] timeout 5
# Start the test.
[Sysname-hwping-administrator-udpprivate] test-enable
# Display test results.
[Sysname-hwping-administrator-udpprivate]
administrator udpprivate
HWPing entry(admin administrator, tag udpprivate) test result:
Chapter 1 HWPing Configuration
display
1-35
hwping results